Apple CS II Guia do Utilizador descarregar pdf (Página 271)

100

101

Unsolder the resistor, scrape the leads with a Stanley knife (gently!).

Clean the solder pads with some 200 grit wet and dry sandpaper. Resolder the

resistor and voila!

If the resistor is OK. Then check the "kickstart" cap in the power supply

(by swapping in a substitute). You can also check the STKxxxx power supply chip

for bad solder joints.

Good luck!

______________________________

From: Rubywand

038- When I play old hires games on my GS the RGB monitor

display does not look as good as my old Amdek Color-1

connected to the II+. What's wrong?

Most hires displays look better on a composite color monitor, such as the

Amdek Color-1, than they do on the GS's RGB monitor. The difference is even more

striking for double-hires displays. (King's Quest and Air Heart look much better

on a Color-1 connected to a IIc+ than on an RGB monitor connected to the GS.)

What's wrong is that the GS's display circuits do just a passable job of

translating hires and double-hires into RGB form.

1 2 ... 266 267 268 269 270 271 272 273 274 275 276 ... 385 386

Comentários a estes Manuais

Sem comentários

Apple CS II Guia do Utilizador Página 271

Comentários a estes Manuais