Apple Ethernet CS Twisted-Pair Card Guia do Utilizador

1The Apple Ethernet CS II Card expands thecommunication capabilities of models of Macintoshcomputers that have a communication slot II (CS II).The car

10Setting the Network Software SelectorTo use your Apple Ethernet CS II card, you must setyour computer to use Open Transport Networking,which provide

11Setting your control panels for EthernetYou must next set the AppleTalk and TCP/IP controlpanels for Ethernet.Setting the AppleTalk control panelA M

124. If you see a pop-up menu that lists zones, select thezone you want.If your network has been set up to allow you tochoose a zone but you have not

13Setting the TCP/IP control panel for EthernetIf you want to connect to an Ethernet network usingTCP/IP network protocols, you need to change thesett

14To disconnect your computer from the network, shutdown your system and unplug the network cable’sconnector from the port on the Ethernet card. Do no

15Following are guidelines for handling commonproblems. If these suggestions don’t help you fix theproblem, contact your network administrator.IMPORTA

16If you can’t select Ethernet in the AppleTalk or TCP/IPcontrol panel: You can only select Ethernet when the networkcable is installed properly and t

17If your system can’t load Ethernet at startup andreverts to LocalTalk:Your System file may be damaged or your Ethernetinstallation was unsuccessful.

18Apple Ethernet CS II Thin Coax CardConnector Ethernet IEEE 802.3– compliant BNC portCable RG-58/U; 2-meter minimumlength between devicesTerminator 5

Apple Ethernet CS II AAUI CardConnector Ethernet IEEE 802.3– compatible AAUI portEthernet transmit/ 10 megabits per second data receive rate maximum P

2Note: You’ll need to obtain the specific cable foryour network separately. If you are not sure whichtransceiver you need, see your network administra

The following books from Apple Computer,published by Addison-Wesley, are available atcomputer bookstores.Planning and Managing AppleTalk Networksprovi

AppleEthernet CS II Card User’s Guide

The equipment described in this manual generates and uses radio-frequency energy. If it is not installed and used properly—that is, in strictaccordanc

Industry CanadaDOC Class B ComplianceThis digital apparatus does not exceed the Class B limits for radio noiseemissions from digital apparatus set out

This equipment has been tested and found to comply with the limits for aClass A digital device pursuant to Part 15 of the Federal CommunicationsCommis

This manual is copyrighted by Apple or by Apple’s suppliers, with allrights reserved. Under the copyright laws, this manual may not becopied, in whole

3IMPORTANTIf you’re installing the Apple Ethernet CS II Thin Coax Card, a T-connector is connected toyour card. Before you install the card, twist the

4To connect your card to the network, follow theinstructions for your specific card. Check theillustration below to determine your card type.Refer to

5Connecting an Apple Ethernet CS II Coax CardIMPORTANTConnecting your computer to thenetwork will temporarily disrupt services to otherusers, so work

65. Attach your T-connector to the port on your card. It may help to use two hands. With one hand,push the T-connector on the port. While stillholding

7Connecting an Apple Ethernet CS IIAAUI Card1. Plug the AAUI connector from your networktransceiver cable into the AAUI port on your card.You need a s

8If you purchased a new Macintosh with an AppleEthernet CS II card, you may already have therequired software installed.If a PCI Network Installer dis

9To install Ethernet software:1. Insert the PCI Network Installer disk in yourMacintosh and double-click the disk’s icon to open it.The Apple Etherne