Apple Xserve (Slot Load) Manual do Utilizador descarregar pdf (Página 47)

Installing Your Server in a Rack 47

Installing the Server in a Two-Post (Telco) Rack

The server attaches to a two-post rack at the center of the enclosure, so that the front and

back of the server extend beyond the rack.

Follow these steps to install the server in a two-post rack. (These instructions assume that

you have previously taken the cover off the server; see “Preparing the Server for Installation”

on page 25 for details.)

1 Attach the small L-shaped brackets to the sides of the server enclosure’s cover with four of

the short screws provided.

Important Before installing the server in a two-post rack, make certain that the rack is

securely fastened to the ﬂoor. Also check the rack’s documentation for any speciﬁc

installation instructions.

Attach the two telco mounting brackets to the server’s cover

using four of the short screws provided.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 87 88

Sem comentários

Apple Xserve (Slot Load) Manual do Utilizador Página 47