Apple Xserve (Slot Load) Manual do Utilizador descarregar pdf (Página 69)

Installing or Replacing Server Components 69

Install a PCI Card in a Long Card Slot

Follow these steps to install a PCI card in one of the long PCI slots.

1 Shut down the server.

Be sure to alert users that the server will be unavailable for a period of time.

2 Disconnect the power cord from the back panel of the server. (If the cable-management arm

is not attached, you will also have to disconnect cables from the back panel.)

3 Loosen the thumbscrew on the back panel for the PCI slot that you want to use and swivel

open the small metal piece that holds the thumbscrew.

Also grasp the slot cover and remove it through the slot opening, if possible.

You can skip this step if there is already a card in the slot you want to use.

4 Move to the front of the server and open it to its full length.

See “Opening and Closing the Server” on page 61 for details.

You can also remove the server from the rack (leaving the cover in place) and install the card

with the server on a sturdy ﬂat surface.

Warning The only way to disconnect power completely is to unplug the power cord.

Make sure that the cord is disconnected before removing or installing any components

inside the server.

Loosen the thumbscrew and

swing the small metal plate

to its open position.

1 2 ... 64 65 66 67 68 69 70 71 72 73 74 ... 87 88

Sem comentários

Apple Xserve (Slot Load) Manual do Utilizador Página 69