Apple Xserve Intel (Late 2006) DIY Procedure for Logic B Manual do Utilizador descarregar pdf (Página 22)

Xserve (Late 2006) Logic Board Replacement Instructions 22

Tighten the ve Phillips screws that fasten the airow duct to the fan array, in the order

shown, to prevent the duct from warping. Do not overtighten the screws.

Replacing the FB-DIMMs

Important: Be sure to install each FB-DIMM in the slot on the replacement board that is

equivalent to the slot you removed it from on the original logic board.

Align the rst FB-DIMM with its slot and press down until the latches snap back up into

place.

Note: The FB-DIMM is designed to t into the slot only one way. Be sure to align the notch in

the FB-DIMM with the small rib inside the slot.

Repeat for the remaining FB-DIMMs.

ConnectorsNotchEjectors

1 2 ... 17 18 19 20 21 22 23 24 25

Sem comentários

Apple Xserve Intel (Late 2006) DIY Procedure for Logic B Manual do Utilizador Página 22