Apple Xserve Guia de Configuração descarregar pdf (Página 17)

Xserve RAID Take Apart -

Controller Module

Procedure

1. Press apart the two latches on the back of the controller module.

2. Holding the controller module by the latches, pull it straight back out of the enclosure.

3. If you are removing the controller card from the case, remove the two screws on the

front of the case, and slide out the bottom half of the case.

Note:

The controller card is attached to the bottom of the controller module case. Do not

attempt to separate the card from the bottom case.

Replacement Note:

If you are replacing the controller card with a new card, you must

transfer the processor and memory modules to the replacement card.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 68 69

Sem comentários

Apple Xserve Guia de Configuração Página 17