Apple Qmaster 2 and Compressor 2 (Distributed Processing Manual do Utilizador descarregar pdf (Página 41)

Chapter 4

Creating and Administering Clusters

Configuring Service Node Processing

Use the Apple Qmaster pane in System Preferences or Apple Qadministrator to set

processing services on a computer.

To turn on processing services:

Open the Apple Qmaster pane in System Preferences.

Optionally, you can configure a number of settings before you turn on the processing

services. (See “

Options in the Apple Qmaster Pane in System Preferences” on page 42.)

Note:

It’s easiest to do this now because you can’t make these settings when

processing services are enabled. To make these settings after services have been

enabled, you need to turn off the services, make the settings, and then turn the

services on again.

In the “Share this computer as” section, select one of the following buttons:

“QuickCluster with services”

“Services and cluster controller”

“Services only”

In the Services section, do one of the following:

In the Share column, select the checkbox for Compressor Processing (for Compressor

services).

In the Share column, select the checkbox for Rendering (for Apple Qmaster services).

Click Start Sharing.

The processing service is enabled, making this computer a service node that can

process batches.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 73 74

Sem comentários

Apple Qmaster 2 and Compressor 2 (Distributed Processing Manual do Utilizador Página 41