Apple Xserve Intel (Late 2006) DIY Procedure for Process Manual do Utilizador descarregar pdf (Página 9)

Xserve (Late 2006) Processor Replacement Instructions 9

Replacing the Processor Heat Sink

Holding the heat sink in one hand, reconnect the 2-pin thermal sensor cable for the heat

sink to the logic board.

Note: Make sure the connector on the sensor cable is oriented as illustrated, with the gold

ngers facing up.

Carefully seat the heat sink over the processor, aligning the four screws with the holes in the

logic board.

Tighten the four captive Phillips mounting screws for the heat sink in the order indicated

below. Do not over-tighten the screws.

1 2 3 4 5 6 7 8 9 10 11

Sem comentários

Apple Xserve Intel (Late 2006) DIY Procedure for Process Manual do Utilizador Página 9