Apple Processor Cage and Clips Guia de Instalação descarregar pdf (Página 116)

F Identifying Physical Locations of the Logical Cage

Numbers

Use the following CLI commands to identify the physical locations of the logical cage numbers.

Enter the numbers into the diagram below and then store them on the storage system admin volume

by following these instructions.

1. Issue showcage to display the drive cage numbers/names

2. Issue locatecage cage<n> where cage<n> is the drive cage number/name, to blink the

LEDs on the front of the drive cage. This will be performed one cage at a time.

3. Once the physical location of the drive cage is identified, make a note of the drive cage

number on a separate paper for reference during servicing.

NOTE: Table below provides example of drive cage numbering.

4U4U4U

1U1U1U

4U4U4U

Cage rack 2Cage rack 1Node rack

4. Issue setcage position "Rack<xx> Rack-Unit<yy>" cage<n>, where <xx> is the

rack designator (00 is the main rack which has nodes, and 01 or higher are expansion

cabinets), <yy> is the Rack-Unit number in the rack (e.g., 1 – 50) at the bottom of the drive

cage, and cage <n> is the logical drive cage number/name.

5. Issue showcage -d cage<n> to verify these settings.

6. Repeat for each drive cage displayed in step 1.

7. Exit and logout of the SPMAINT session.

116 Identifying Physical Locations of the Logical Cage Numbers

1 2 ... 111 112 113 114 115 116 117

Sem comentários

Apple Processor Cage and Clips Guia de Instalação Página 116