
The HP 3PAR Service Processor is setup is now complete. Continue on to “Launching the HP 3PAR
Storage System Setup Wizard” (page 85).
Launching the HP 3PAR Storage System Setup Wizard
The setup wizard proceeds through the following steps:
• Welcome
• Enter Storage System
• Verify Storage System
• Configure Networking
• Configure Time
• Change Password
• Verify Configuration
• Progress
• Results
To launch the storage system setup wizard in SmartStart:
1. Click the Setup storage system link in SmartStart wizard step 3, Setup storage system.
Figure 59 Setup Storage System
2. Enter the SP IP address. Click Ok.
NOTE: When configuring in a DHCP network environment, enter the VSP temporary IP
address.
NOTE: The Storage System Setup Wizard may not display correctly when using Microsoft
Internet Explorer 10 with default security settings. If the wizard continues to display incorrectly,
try refreshing the browser page.
Launching the HP 3PAR Storage System Setup Wizard 85
Comentários a estes Manuais