Apple Xserve G5 Guia do Utilizador descarregar pdf (Página 14)

14 Chapter 1

Installing Your Xserve G5 PCI Hardware RAID Card

Remove the PCI fan by prying off its cover and lifting the fan and cover up above the

server.

Removing the fan allows you to connect the cables to the RAID card and to determine

which connectors need to go where.

Disconnect the cables that attach the fan and cover to the main logic board and set

the fan and cover aside.

Locate and remove the existing main logic board SATA cables.

You should save these cables in case you ever want to remove the RAID card from your

Xserve and re-enable the main logic board SATA controllers.

You can use a flat-blade screwdriver to pry

off the PCI fan and cover. Insert the screwdriver

blade next to the tab on the side of the server

and carefully pop the cover straight up. Do not

yank the assembly away, because it is still

attached to the server by a cable.

Unplug these six connectors and

remove the cable assembly from the server.

Save the assembly in case you ever remove

the RAID card.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Sem comentários

Apple Xserve G5 Guia do Utilizador Página 14