Apple Xserve G5 Guia do Utilizador descarregar pdf (Página 15)

Chapter 1

Installing Your Xserve G5 PCI Hardware RAID Card

Locate the SATA cables provided with the PCI Hardware RAID Card kit. Check the

lengths of the three cables for the hardware RAID card and connect the straight end of

each cable to the RAID card's ports in the following sequence:

•

Longest cable (blue banded) to port 0 (the port nearest the metal “fence” at the end)

•

Middle-length cable (red banded) to port 1 (second from fence)

•

Shortest cable (white banded) to port 2 (third from fence)

Important:

Do not connect any cable to port 3. This port cannot be used.

Connect the right-angle end of each cable to the ports on the drive module controller

board as follows:

•

Shortest cable to the connector marked Drive 3

•

Middle-length cable to the connector marked Drive 2

•

Longest cable to the connector marked Drive 1

Do not plug any cable

into this connector (port 3).

Do not plug any cables

into these connectors.

The middle cable

plugs into this

connector (drive 2).

The longest

cable plugs into

this connector

(port 0).

The middle

cable plugs into

this connector

(port 1).

The shortest

cable plugs into

this connector

(port 2).

The shortest

cable plugs into

this connector

(drive 3).

The longest

cable plugs into

this connector

(drive 1).

Warning:

Be sure to connect the cables exactly as described here or unreliable

operation may result.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comentários a estes Manuais

Sem comentários

Apple Xserve G5 Guia do Utilizador Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Barebones PC/estação de trabalho Apple Xserve G5