Apple Xserve (Early 2008) DIY Procedure for Enclosure Manual do Utilizador descarregar pdf (Página 103)

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 7

Caution: Each heat sink is connected to the logic board by a small 2-pin thermal sensor 2.

cable. Lifting the heat sink too quickly can damage the cable or connector. Because of

the tight thermal bond between the processor and heat sink, be especially cautious to

initially lift the heat sink no more than one centimeter (1 cm) o the processor. Do not

pull on the cable as you lift the heat sink enough to disconnect the cable from the logic

board.

Slowly raise the heat sink o the processor just far enough that you can reach the sensor

cable connector.

Pull on the connector, not the cable, to disconnect the sensor cable from the logic board. 3.

Lift the heat sink straight up and out of the enclosure.4.

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 168 169

Sem comentários

Apple Xserve (Early 2008) DIY Procedure for Enclosure Manual do Utilizador Página 103