Apple Xserve (Early 2008) DIY Procedure for Enclosure Manual do Utilizador Página 165

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 169
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 164
Xserve (Late 2006/Early 2008) Rear ID Tab Replacement Instructions 24
Carefully seat the heat sink over the processor, aligning the four screws with the holes in the 11 .
logic board.
Tighten the four captive Phillips mounting screws for the heat sink in the order indicated 12.
below. Do not over-tighten the screws. If you have a torque driver, tighten the screws to 8
inch-pounds; otherwise, try to tighten the screws with equal pressure.
Replacing the Backplane-to-Logic Board I/O Cable
Fold the replacement cable to a 90-degree angle along its creases. 1.
Vista de página 164
1 2 ... 160 161 162 163 164 165 166 167 168 169

Comentários a estes Manuais

Sem comentários