Apple Xserve (Early 2008) DIY Procedure for Enclosure Manual do Utilizador descarregar pdf (Página 108)

Xserve (Late 2006/Early 2008) Processor Heat Sink Replacement Instructions 12

Carefully seat the heat sink over the processor, aligning the four screws with the holes in the 11 .

logic board.

Tighten the four captive Phillips mounting screws for the heat sink in the order indicated 12.

below. Do not over-tighten the screws. If you have a torque driver, tighten the screws to 8

inch-pounds; otherwise, try to tighten the screws with equal pressure.

Replacing the Airow Duct

Lower the airow duct into position on the logic board. 1.

Note: When installing the airow duct, be sure to route both the front panel board cable and

the backplane-to-logic board I/O cable inside the channel under the left side of the duct.

1 2 ... 103 104 105 106 107 108 109 110 111 112 113 ... 168 169

Sem comentários

Apple Xserve (Early 2008) DIY Procedure for Enclosure Manual do Utilizador Página 108