Apple Xserve (Early 2008) DIY Procedure for Enclosure Manual do Utilizador descarregar pdf (Página 85)

Xserve (Late 2006/Early 2008) Power Distribution Board Replacement Instructions 3

Removing the Installed Power Distribution Board

Note: Before removing the power distribution board, you must remove the following:

All Apple drive modules•

Both power supplies•

Power distribution board cable•

Airow duct•

Fan array•

Drive interconnect backplane•

Apple Drive Modules

Press the handle on the front of the drive module so that the handle pops out. Then grasp 1.

the drive handle, and pull the drive module out of the Xserve.

Repeat for all other installed drive modules.2.

Power Supplies

Pull the handle to release the rst power supply and slide it out of the bay.1.

Repeat for the second power supply, if installed.2.

Pull the handle to unlatch the

power supply and remove it.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 168 169

Sem comentários

Apple Xserve (Early 2008) DIY Procedure for Enclosure Manual do Utilizador Página 85