Apple Xserve (Early 2008) DIY Procedure for Enclosure Manual do Utilizador descarregar pdf (Página 155)

Xserve (Late 2006/Early 2008) Rear ID Tab Replacement Instructions 14

Disconnect the optical drive cable from the logic board.2.

Release the two locking levers on the front panel board cable connector and disconnect the 3.

cable from the logic board. Move the cable aside so you have access to the logic board.

Loosen the single thumbscrew on the power distribution board and slide the board away 4.

from and out of the connector on the logic board.

Note: Don’t remove the power distribution board but make sure its edge connector is all the

way out of the connector on the logic board.

1 2 ... 150 151 152 153 154 155 156 157 158 159 160 ... 168 169

Sem comentários

Apple Xserve (Early 2008) DIY Procedure for Enclosure Manual do Utilizador Página 155