Apple 12/640PS Informações Técnicas Página 266

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
Vista de página 265
2 Open the TCP/IP Configuration category.
A panel appears in which you can enter the IP address.
3Enter the IP address.
4 Drag the slider to set the printer’s subnet mask.
5Enter the default Gateway Address.
6Click Send to send the TCP/IP configuration to the printer.
Viewing and changing communication settings
The standard communication settings of the LaserWriter 12/640 PS work for
most environments. To make sure the printer is set up to use the standard
settings, check that the communication switch on the left side of the printer is
in the Normal (in) position. The switch is located below the interface
connectors.
You can view and change the standard communication settings for the printer
with the Apple Printer Utility. The NetWare, TCP/IP, and Parallel interfaces
are set to AutoSelect, which turns on automatic language sensing. Automatic
language sensing allows the printer to receive information over the network
and determine which page-description language—PostScript or PCL5—is
required.
266
Appendix A
Type the IP address here.
IP address of the default
gateway used for sending
packets off the local network
Drag the slider to
change the printer’s
subnet mask.
You can drag the
slider only if the
printer’s IP address
is not 0.0.0.0.
Vista de página 265
1 2 ... 261 262 263 264 265 266 267 268 269 270 271 ... 353 354

Comentários a estes Manuais

Sem comentários